TUNDISH NOZZLE
Upper nozzle(Stationary nozzle)
is located within the tundish lining and conveys steel to the controlling exchangeable nozzle,
which determines the steel flow. The stationary nozzle must be capable of withstanding long sequence times. Our Upper nozzle that incorporates a ultra-high density insert.
The insert provides excellent erosion resistance and can provide extended casting sequence times. The lower surface of the stationary nozzle is ground to exacting tolerances to ensure maximum surface contact between the two nozzle components.
Lower Nozzle (EXCHANGABLE)
is located within an assembly that is fixed to the bottom of the tundish. The design of the exchangeable nozzle can vary according to the system manufacturer.
We are supplying a range of zirconia inserts and composite nozzle designs for the exchangeable metering of steel. Zirconia inserts can be supplied for on-site assembly into metallic holding blocks where cementing, grinding, size banding and on site drying are required prior to use.
It was manufactured by both cast process of fine grained alumina method or presse process.
|
|
Zirconia Inserts |
Tundish Nozzle Outer |
||||
|
Physical Properties |
||||||
|
Apparent Porosity (%) |
11-12 |
8-10 |
6-8 |
20 |
18 |
16 |
|
Bulk Density (g/cm3) |
≥4.9 |
≥5.2 |
≥5.3 |
2.6 |
2.8 |
3 |
|
Chemical Analysis(%) |
||||||
|
ZrO2 |
≥94.0 |
≥95.5 |
≥95.5 |
/ |
/ |
/ |
|
Al2O3 |
/ |
/ |
/ |
≥75 |
≥85 |
≥90 |
